This is an old revision of the document!
A: Issues with the parameters of your simulation are the result of an invalid/incorrect input.
First, select each geometry in grasshopper to ensure you have referenced the correct thing.
If those are correct, go input by input (skip SS) on the solver block to try and find your issue.
C: Are your geometries connected to Intact Component blocks? Are you defining an appropriate material (make sure to not use thermal materials for stress simulations and vise versa)
R: If you are using fixed restraints, are your geometries attached to a fix restraint block? If you are using displacement boundary conditions, do you have an x, y, and z displacement defined? It is required to have all three translational degrees of freedom defined.
L: Double check all parameters on your loads have been defined. Ensure the load is being placed in the place you want it to be (check geometry). Are you connecting body loads to the loads input? If so, connect those to LV.
LV: This input is for body loads only. These are body weight loads and linear/rotational acceleration loads.
B: