Differences

This shows you the differences between two versions of the page.

--- wiki:sns:snspro:using_wood_materials [2017/07/17 09:19] – claire
+++ wiki:sns:snspro:using_wood_materials [2023/12/13 13:43] (current) – [Related Videos] michael
@@ Line 8: / Line 8: @@
 **Important Note:** The material coordinate system convention used by Scan&Solve is different from that used by the wood industry where axis 2 is usually the radial direction and axis 3 is tangential to the growth rings. The Scan&Solve convention is derived from the system commonly used for composites, with the wood's growth direction analogous to the composite build direction (axis 3). Mechanical properties defined in one convention are related mathematically to those in the other, so conversion between the two is possible.
-===== Wood Material Tab =====
+{{ :wiki:sns:snspro:wood1.png?450|}}
-{{ :wiki:sns:snspro:wood1.png?400|}}
+===== Wood Material Tab =====
 The material selector contains a tab listing the available wood materials. The grain orientation may then be specified using one of these 4 options:
@@ Line 83: / Line 83: @@
 <WRAP group>
 <WRAP half column>
-{{youtube>large:ZdErK9zSay0}}
+{{youtube>ZdErK9zSay0?large}}
-{{youtube>large:NHRqmAX_CDI}}
+{{youtube>NHRqmAX_CDI?large}}
 </WRAP>
 <WRAP half column>
-{{youtube>large:6Hz8nP_bHXc}}
+{{youtube>6Hz8nP_bHXc?large}}
-{{youtube>large:j-t3_11RuVw}}
+{{youtube>j-t3_11RuVw?large}}
 </WRAP>
 </WRAP>