wiki:sns:snspro:restraining_partial_faces_and_edges
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
wiki:sns:snspro:restraining_partial_faces_and_edges [2017/07/14 12:10] – claire | wiki:sns:snspro:restraining_partial_faces_and_edges [2017/07/17 10:42] (current) – claire | ||
---|---|---|---|
Line 4: | Line 4: | ||
In the Rhino viewport, the faces of a closed solid polysurface are outlined with bold edges. If the existing faces or edges of the solid do not reflect the desired restraints, the Rhino " | In the Rhino viewport, the faces of a closed solid polysurface are outlined with bold edges. If the existing faces or edges of the solid do not reflect the desired restraints, the Rhino " | ||
- | ===== Using the Split Face function | + | ===== Using the Split Face Command===== |
In the process pictured below, the top face of an existing solid is carved into two parts using the "Split Face" function. One edge will also be divided into three parts. | In the process pictured below, the top face of an existing solid is carved into two parts using the "Split Face" function. One edge will also be divided into three parts. | ||
Line 15: | Line 15: | ||
- **Ready to Restrain:** After splitting is complete, SnSPro' | - **Ready to Restrain:** After splitting is complete, SnSPro' | ||
- | ===== Using the Split function | + | ===== Using the Split Command |
In the process pictured below, the top face of an existing solid is carved into two parts using the " | In the process pictured below, the top face of an existing solid is carved into two parts using the " |
wiki/sns/snspro/restraining_partial_faces_and_edges.1500055803.txt.gz · Last modified: 2017/07/14 12:10 by claire