Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:thermal_bc [2023/04/27 13:33] – goldy
+++ wiki:sns:intactgh:thermal_bc [2023/08/15 08:24] (current) – eli
@@ Line 7: / Line 7: @@
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:thermal_boundary_condition.png?200|}}
+{{ :wiki:sns:intactgh:thermal_solver_block_surface.png?200 }}
 </WRAP>
@@ Line 17: / Line 17: @@
 A Temperature boundary condition requires two inputs:
-  * the geometry of the surfaces where the temperature is fixed
+  * G: the geometry of the surfaces where the temperature is fixed
-  * the magnitude of the temperature in [[consistent_units|temperature units]]
+  * T: the magnitude of the temperature
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:temperaturebc.png?200|}}
+{{ :wiki:sns:intactgh:temperaturebc.png?200 }}
 </WRAP>
@@ Line 30: / Line 30: @@
 A thermal convection boundary condition requires three inputs:
-  * the geometry of the surfaces where the convection is specified.
+  * G: the geometry of the surfaces where the convection is specified.
-  * the coefficient of convection in [[consistent_units|convection coefficient units]]
+  * C: the coefficient of convection
-  * the temperature of the surrounding medium in [[consistent_units|temperature units]]
+  * Te: the temperature of the surrounding medium
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:convectionbc.png?200|}}
+{{ :wiki:sns:intactgh:convectionbc.png?200 }}
 </WRAP>
@@ Line 45: / Line 45: @@
 A surface thermal flux requires two inputs:
-  * the geometry of the surfaces where the heat flux is applied
+  * G: the geometry of the surfaces where the heat flux is applied
-  * the magnitude of the heat flux in [[consistent_units|surface heat flux units]]
+  * HF: the magnitude of the heat flux
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:thermalfluxbc.png?200|}}
+{{ :wiki:sns:intactgh:thermalfluxbc.png?200 }}
 </WRAP>