Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:thermal_bc [2023/04/26 16:52] – paul
+++ wiki:sns:intactgh:thermal_bc [2023/08/15 08:24] (current) – eli
@@ Line 4: / Line 4: @@
 ====== Thermal Boundary Conditions ======
 <WRAP half column>
-tk
+Thermal boundary conditions are applied to faces of the components participating in the simulation by connecting to the boundary condition input on the thermal solver component
 </WRAP>
+<WRAP half column>
+{{ :wiki:sns:intactgh:thermal_solver_block_surface.png?200 }}
+</WRAP>
 ===== Temperature Load =====
 <WRAP half column>
-tk
+A "Temperature" boundary condition fixes the temperature at the chosen boundary at the specified temperature.
+A Temperature boundary condition requires two inputs:
+  * G: the geometry of the surfaces where the temperature is fixed
+  * T: the magnitude of the temperature
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:temperaturebc.png?200|}}
+{{ :wiki:sns:intactgh:temperaturebc.png?200 }}
 </WRAP>
 ===== Thermal Convection =====
 <WRAP half column>
-tk
+"Thermal Convection" specifies the transfer of heat from a surrounding medium.
+A thermal convection boundary condition requires three inputs:
+  * G: the geometry of the surfaces where the convection is specified.
+  * C: the coefficient of convection
+  * Te: the temperature of the surrounding medium
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:convectionbc.png?200|}}
+{{ :wiki:sns:intactgh:convectionbc.png?200 }}
 </WRAP>
 ===== Thermal Flux =====
 <WRAP half column>
-tk
+Surface "Thermal or Heat Flux" specifies the heat flow per unit of surface area.
+A surface thermal flux requires two inputs:
+  * G: the geometry of the surfaces where the heat flux is applied
+  * HF: the magnitude of the heat flux
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:thermalfluxbc.png?200|}}
+{{ :wiki:sns:intactgh:thermalfluxbc.png?200 }}
 </WRAP>