wiki:sns:intactgh:surface_loads
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
wiki:sns:intactgh:surface_loads [2023/05/26 11:11] – paul | wiki:sns:intactgh:surface_loads [2024/08/21 09:07] (current) – [Pressure] goldy | ||
---|---|---|---|
Line 7: | Line 7: | ||
</ | </ | ||
<WRAP half column> | <WRAP half column> | ||
- | {{ : | + | {{ : |
</ | </ | ||
Line 21: | Line 21: | ||
</ | </ | ||
<WRAP half column> | <WRAP half column> | ||
- | {{ : | + | {{ : |
</ | </ | ||
</ | </ | ||
Line 35: | Line 35: | ||
</ | </ | ||
<WRAP half column> | <WRAP half column> | ||
- | {{ : | + | {{ : |
</ | </ | ||
</ | </ | ||
Line 41: | Line 41: | ||
<WRAP group> | <WRAP group> | ||
<WRAP half column> | <WRAP half column> | ||
- | A " | + | A " |
A Pressure Load requires two inputs: | A Pressure Load requires two inputs: | ||
Line 48: | Line 48: | ||
</ | </ | ||
<WRAP half column> | <WRAP half column> | ||
- | {{ : | + | {{ : |
</ | </ | ||
</ | </ | ||
Line 62: | Line 62: | ||
</ | </ | ||
<WRAP half column> | <WRAP half column> | ||
- | {{ : | + | {{ : |
+ | </ | ||
+ | </ | ||
+ | |||
+ | |||
+ | ===== Hydrostatic Load ===== | ||
+ | <WRAP group> | ||
+ | <WRAP half column> | ||
+ | A “Hydrostatic” load is a spatially varying pressure as experienced by the walls of a pool due to the weight of the water pressing against them. The pressure at any point depends on the density of the water, increasing from a value of zero at the water surface to a maximum at the deepest point. | ||
+ | |||
+ | A Hydrostatic load requires three inputs: | ||
+ | * the geometry of the surfaces where the load is applied | ||
+ | * a point on the surface of the fluid (fluid depth is assumed in the -Z direction) | ||
+ | * specific gravity of the fluid (dimensionless, | ||
+ | </ | ||
+ | <WRAP half column> | ||
+ | {{ : | ||
</ | </ | ||
</ | </ |
wiki/sns/intactgh/surface_loads.1685121082.txt.gz · Last modified: 2023/05/26 11:11 by paul