wiki:sns:intactgh:slidingbc
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| wiki:sns:intactgh:slidingbc [2023/10/17 14:52] – created paul | wiki:sns:intactgh:slidingbc [2023/11/20 19:14] (current) – eli | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== Sliding Boundary Condition ====== | ====== Sliding Boundary Condition ====== | ||
| The Sliding Boundary Condition block in Intact.Simulation for Grasshopper can allow sliding on an arbitrary surface, by fixing the displacement normal to the surface to zero. It can be used, for example, to model pin joints which allow rotation around a cylindrical surface. | The Sliding Boundary Condition block in Intact.Simulation for Grasshopper can allow sliding on an arbitrary surface, by fixing the displacement normal to the surface to zero. It can be used, for example, to model pin joints which allow rotation around a cylindrical surface. | ||
| + | |||
| ===== Usage ===== | ===== Usage ===== | ||
| + | <WRAP group> | ||
| + | <WRAP half column> | ||
| A Sliding Boundary Condition block has one input: | A Sliding Boundary Condition block has one input: | ||
| * the geometry of the surface along which to allow sliding (must be specified) | * the geometry of the surface along which to allow sliding (must be specified) | ||
| The output should be given to the Load input on a Stress Solver block. | The output should be given to the Load input on a Stress Solver block. | ||
| + | |||
| + | <WRAP center round box 60%> | ||
| + | 📌 See sliding boundary condition example: [[wiki: | ||
| + | </ | ||
| + | |||
| + | </ | ||
| + | <WRAP half column> | ||
| + | {{ : | ||
| + | </ | ||
| + | </ | ||
wiki/sns/intactgh/slidingbc.1697575957.txt.gz · Last modified: 2023/10/17 14:52 by paul