wiki:sns:intactgh:getting_started
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
wiki:sns:intactgh:getting_started [2023/05/16 09:42] – goldy | wiki:sns:intactgh:getting_started [2024/02/05 08:45] (current) – [Quick Start Guide] goldy | ||
---|---|---|---|
Line 1: | Line 1: | ||
======Getting Started====== | ======Getting Started====== | ||
- | *[[wiki: | + | *[[wiki: |
*[[wiki: | *[[wiki: | ||
*[[wiki: | *[[wiki: | ||
Line 6: | Line 6: | ||
===== Quick Start Guide ===== | ===== Quick Start Guide ===== | ||
- | See the following videos to get started with Intact.Simulation Grasshopper Plugin quickly. | + | See the following videos to get started with Intact.Simulation Grasshopper Plugin quickly.\\ |
+ | ** Note: the videos utilize Rhino 7 so there may be some minor discrepancies, | ||
Download **demo files** using the link below to use our example. | Download **demo files** using the link below to use our example. | ||
- | {{ : | + | {{ : |
+ | {{ : | ||
==== A. Setting Up Your First Simulation ==== | ==== A. Setting Up Your First Simulation ==== | ||
Line 36: | Line 38: | ||
* Create a component from the design geometry and specify the appropriate material | * Create a component from the design geometry and specify the appropriate material | ||
+ | * Note you can also add blocks by double clicking on the canvas (See [[wiki: | ||
{{ : | {{ : | ||
=== Step 5: Specify Boundary Condition === | === Step 5: Specify Boundary Condition === |
wiki/sns/intactgh/getting_started.1684251746.txt.gz · Last modified: 2023/05/16 09:42 by goldy