Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:ex_2 [2024/01/31 14:30] – graham
+++ wiki:sns:intactgh:ex_2 [2024/02/05 12:57] (current) – graham
@@ Line 1: / Line 1: @@
 ======Ex-2: Thermal simulation of a heat sink======
-🧰The Rhino and Grasshopper files used in this example can be downloaded here: {{:wiki:sns:intactgh:gyroid_heat_sink.zip}}
+🧰The Rhino and Grasshopper files used in this example can be downloaded here: {{:wiki:sns:intactgh:gyroid_heat_sink.zip}} \\
+*Legacy* files for Rhino 7 can also be found here: {{:wiki:sns:intactgh:gyroid_heat_sink_rhino7.zip}}
 This example demonstrates how to simulate heat transfer of a heat sink as shown in the picture below. This geometry is generated in [[https://www.ntop.com/|nTop]].
@@ Line 45: / Line 47: @@
 {{ :wiki:sns:intactgh:ex2_e.png |}}
-The temperature distribution of the bonded assembly is displayed below, which shows that the max min temperatures is approximately 320K and 292K, respectively.
+The temperature distribution of the bonded assembly is displayed below, which shows that the max-min temperature is approximately 320K and 292K, respectively.
 {{ :wiki:sns:intactgh:ex2_f.png? |}}