Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:ex_1 [2023/09/19 09:20] – eli
+++ wiki:sns:intactgh:ex_1 [2024/02/01 13:14] (current) – graham
@@ Line 2: / Line 2: @@
 =====Video Walkthrough=====
+* Note: this video was made with Rhino 7 so some minor changes may be present, the workflow remains consistent though. *
 {{ :wiki:sns:intactgh:ex1_final.mp4?900 |}}
-🧰 The Rhino and Grasshopper files used in this example can be downloaded here: {{ :wiki:sns:intactgh:connecting_rod_assembly.zip |}}
+🧰 The Rhino and Grasshopper files used in this example can be downloaded here: {{ :wiki:sns:intactgh:connecting_rod_assembly.zip |}} \\
+*Legacy* files for Rhino 7 can also be found here: {{:wiki:sns:intactgh:connecting_rod_assembly_rhino7.zip}}
 This example demonstrates how to simulate a lattice infilled part, which is a bonded assembly of a lattice infill (STL) and an outer geometry (B-rep) as shown in the picture below.
@@ Line 25: / Line 29: @@
   * Use the merge block to join the two components as a bonded assembly as shown in (f)
-{{ :wiki:sns:intactgh:ex1_b.png?400 |}}
+{{ :wiki:sns:intactgh:ex1_b.png |}}
 =====Applying loads and boundary conditions=====
@@ Line 35: / Line 39: @@
   * Create a vector load block and connect the loading surface, the magnitude of the force, and the direction as shown in (f)
-{{ :wiki:sns:intactgh:ex1_c.png?600 |}}
+{{ :wiki:sns:intactgh:ex1_c.png |}}
 =====Setup solver=====
   * Create a solver settings block as shown in (a)
@@ Line 48: / Line 52: @@
   * Hit solve to compute the solution
-{{ :wiki:sns:intactgh:ex1_d.png?200 |}}
+{{ :wiki:sns:intactgh:ex1_d.png |}}
 =====Setup visualization block=====
@@ Line 55: / Line 59: @@
   * Right click on the visualize block and choose the simulation output for display (e.g. Von Mises stress or total displacement).
-{{ :wiki:sns:intactgh:ex1_e.png?200 |}}
+{{ :wiki:sns:intactgh:ex1_e.png |}}