Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:basic_operation [2022/08/23 19:00] – michael
+++ wiki:sns:intactgh:basic_operation [2024/01/30 13:11] (current) – graham
@@ Line 4: / Line 4: @@
   - Run Grasshopper by typing **Grasshopper** at the Rhino command line\\
   - Navigate to the Intact.Simulation Toolbar in Grasshopper
-  - Select a **Solver** for the the physics of interest (stress, //thermal*, modal//*)
+  - Select a **Solver** for the the physics of interest (stress, thermal, modal)
   - Add **[[wiki:sns:intactgh:components|components]]** and assign [[wiki:sns:intactgh:materials|material]]
   - Apply **boundary conditions** ([[wiki:sns:intactgh:restraints|restraints]] and [[wiki:sns:intactgh:loads|loads]])
@@ Line 11: / Line 11: @@
 </WRAP>
 <WRAP half column>
-{{:wiki:sns:intactgh:pasted:20220823-180048.png?600}}
+{{ :wiki:sns:intactgh:annotated_toolbar.png?800}}
 </WRAP>
-=====Stress Simulation=====
+=====Stress Simulation quick start=====
-{{:wiki:sns:intactgh:pasted:20220823-181452.png?600}}
 <WRAP group>
 <WRAP half column>
-  - Insert stress solver block
+  - Insert [[stress_solver|stress solver block]]
-  - Specify resolution using number input
+  - Insert [[wiki:sns:intactgh:solver_settings|solver settings block]] to set resolution or grid size
   - Insert simulation [[components|component block]]
     - Specify geometry
-    - Specify [[materials|material]]
+    - Insert and connect [[materials|material]] block
     - Connect components to stress solver
   - Insert [[restraints|restraint block]]
     - Specify surfaces to restrain
-    - //(Optional)// select directions to restrain
     - Connect restraints to stress solver
-  - Insert [[surface_loads|surface load block]] of choice (bearing load shown)
+  - Insert [[surface_loads|surface load block]] of choice (vector load shown)
     - Specify surfaces to load
-    - Specify load particulars
+    - Specify load particulars (such as magnitude or direction)
     - Connect loads to stress solver
-  - Click [Solve] on stress solver component
+  - Click [Solve] on stress solver component (if Boolean is toggled "True" it will solve automatically)
   - Insert [[results|visualization block]]
     - Connect output of stress solver
-    - Select solution quantity of interest
+    - Right click to select solution quantity of interest
 </WRAP>
 <WRAP half column>
-{{:wiki:sns:intactgh:pasted:20220823-185810.png?800}}
+{{:wiki:sns:intactgh:solution_process.png?1200}}
 </WRAP>
 </WRAP>
-* Additional physics on the way.