Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:automation [2024/02/05 13:42] – created goldy
+++ wiki:sns:intactgh:automation [2024/02/06 10:53] (current) – graham
@@ Line 1: / Line 1: @@
-Intact.Simulation ( for Rhino 8 only) supports automation capabilities. Simulation will run automatically when any input to the solver changes.
+Intact.Simulation ( for Rhino 8 only) supports automation capabilities. The simulation will run automatically when any input to the solver changes.
- demonstrates how to simulate heat transfer of a heat sink as shown in the picture below. This geometry is generated in [[https://www.ntop.com/|nTop]].
+[[wiki:sns:intactgh:beginner_ex_6|Variable Geometry Heat Sink Case Study]] demonstrates how to simulate heat transfer of a heat sink as the number of fins are adjusted.
-{{ :wiki:sns:intactgh:variable_sink.mp4?900 }}
+{{ :wiki:sns:intactgh:heatsink_geometrysetup.png }}
+A quick snapshot of how you can use this to do **rapid design studies**.
+{{ :wiki:sns:intactgh:variable_heat_sink_automated_simulation.mp4?600 |}}
+You can switch the solver modes between "Auto" and "Manual" depending on if you want every parameter update to run simulation. It is suggested to leave the solver mode on manual while first setting up a problem and only switching to auto when multiple different inputs are to be tested or compared.
+{{ :wiki:sns:intactgh:auto-manual_mode_-_2.mp4?600 |}}