Differences

This shows you the differences between two versions of the page.

--- wiki:id:intact_automation [2023/11/09 11:41] – goldy
+++ wiki:id:intact_automation [2024/02/22 12:24] (current) – goldy
@@ Line 3: / Line 3: @@
 ===== Intact.Simulation for Automation is available using Command Line Interface. =====
-<WRAP center round tip 90%>
+<WRAP center round tip 60%>
 Example Blog: [[https://www.intact-solutions.com/rev/2023/08/automated-simulation-of-300-design-submissions-to-the-ge-bracket-challenge/
 | Automated Simulation of 300 Design Submissions to GE Bracket Challenge]]
@@ Line 11: / Line 11: @@
-====== Steps ======
+====== Instructions ======
@@ Line 26: / Line 26: @@
 <WRAP center round box 100%>
-. Set up the input Json and provide the geometry file (.VDB, .PLY, .STL) and boundary condition faces (.STL, .PLY)
+   - Set up the input Json and provide the geometry file (.VDB, .PLY, .STL) and boundary condition faces (.STL, .PLY)
-. call intact cli
+   - Call intact cli //$ intact -s "path to json file" --save-solution//
+   - A successful run will result into a *_samples.vtu result file
+   - You can visualize the result view in Paraview (an opensource program, see more in )[[https://intact-solutions.com/intact_docs/cli_manual.html|CLI Documentation]]
-        $ intact -s "path to json file" --save-solution
+   - Also see the CLI Documentation to resample the saved solution on custom points
-. a successful run will result into a *_samples.vtu result file
-. You can visualize the result view in Paraview (an opensource program, see more in the documentation in 3)
 </WRAP>